![]() WHERE CAN I FIND PCB FOR PROTECTION CARD FOR THAT I USE ER元5-C INSTEAD ETD-59 MY Requirements.FOR SUPPLYING SOLID STATE MOSFET AMPLIFIER. The SMPS at the front page is the OLD version of the commercial design I made long time ago.Īnd yes, the proper way is shut down IR2110 at the same time. I am sure that you are talking about the regulated SMPS, and this is not Regulated SMPS. The duty cycle of 3525 is reduced by the DT resistor 100R, can the DT be reduced so that feed back voltage control can be given.Ībout the smps photo given at the front page of the site. V or above LM393 can be replaced wit cheaper TL431.
0 Comments
Leave a Reply. |